New Restaurant Guide

EQUIPMENT INSTALLATION GUIDE

Coffee Makers

KES Installer 1. Unpack and set in position. 2. Verify that the center island and Drive thru has been wired correctly for the type of machine provided. Beverage Installer 1. Run and connect plastic water line from water filter assembly for coffee machine to manifold water line. If water is over 200 TDS then coffee maker is recommended to be hooked up to RO system. Make final connection. 2. Following the water connection by Beverage installer plug into electrical source and perform a quick check to be sure unit is operative.

WARNING: Failure to fill coffee maker with water prior to operation may cause severe damage.

Orange Juice Dispenser (Non-Carbonated Beverage Dispenser)

KES Installer 1. Unpack and set into position.

Beverage Installer 1. Run and connect approved 1/2" beverage tubing from a chilled from a boosted water line in the nearest python to the orange juice machine. Make final connection. 2. Make water connection, plug into electrical source and perform quick check to be sure unit is operative. 3. Train store personnel on operation and maintenance.

Owner Operator 1. Ensure product is available for start-ups and training.

Specialty Coffee Equipment

KES Installer 1. Unpack and set in position.

Beverage Installer 1. Run and connect plastic water line and properly identify all lines from RO source to the specialty coffee machine. Make final connection. 2. Verify TDS of water is within specified range of 50-100ppm. Take corrective action if needed. 3. Contact KES to coordinate start up

WARNING: Failure to fill specialty coffee maker with water prior to operation may cause severe damage.

Specialty Coffee FASC 1. Following the water connection by the Beverage Installer plug into electrical source and perform a quick check to be sure unit is operative. 2. Train store personnel on operation and maintenance.

Owner Operator 1. Ensure product is available for start-ups and training.

4.24