New Restaurant Guide

EQUIPMENT INSTALLATION GUIDE

Tea Brewers

KES Installer 1. Unpack and set into position.

Beverage Installer 1. Run and connect plastic water line from water filter assembly for tea brewer to manifold water line. Make final connection. 2. Following the water connection by Beverage Installer plug into electrical source and perform a quick check to be sure unit is operative. 3. Train store personnel on operation and maintenance.

WARNING: Failure to fill tea maker with water prior to operation may cause severe damage.

Owner Operator 1. Ensure product is available for start-ups and training.

Blended Ice Machine

KES Installer 1. Unpack and set into position.

Beverage Installer 1. Run plastic water line and properly identify all lines from boosted and pre-filtered water assembly and make final connection. 2. Run approved CO2 line from back room and make final connection. 3. Contact KES to coordinate start up Blended Ice FASC 1. Following water and CO2 connection by Beverage Installer plug into electrical source and perform a quick check to be sure unit is operative. 2. Train store personnel on operation and maintenance

Owner Operator 1. Ensure product is available for start-ups and training.

RO System

KES Installer 1. Leave in box and place near beverage system.

Beverage Installer 1. Mount and install RO and storage tank. 2. Run and connect approved plastic line from water booster. 3. Install sample valves. 4. Verify TDS of water is within specified range of 50-100ppm. Take corrective action if needed. 5. Perform a quick check to ensure operative. 6. Train store personnel on operation and maintenance.

4.25